Our engineering teams have been selected for their wide range of abilities and competency in mechanical, electrical and electronics engineering. We are also capable of providing the best maintenance support including fast response and trouble-shooting support by our own locally and overseas trained engineers and technicians. Click Here for more details
 |
| illustration purpose only |
Hakita’s designed and XYZ axis of Engine Bed with the main focus of having precise and easy alignment for the shaft coupling between the engine and the dynamometer. The Engine Bed has the advantages of a low installation cost and enabling rapid engine change, allowing maximum accessibility to the engine and the ability to support engines with a wide range of physical sizes and power.
Click Here to see our EVETS ( TEST BEDS COMPONENTS ) Products
 |
| illustration purpose only |
In most cases, the thickness of the material that can be cut will not just depend on the strength of the material, but also on the lateral flexibility of the material to allow the cutter to penetrate down into, and pass through the material. In other words, if the material is too rigid, the thickness of the material that can be cut will be reduced because the outside edges of the cutter blades will bind in the material, and therefore reduce the available cutting force. The press generates on average up to 600kg (6KN) of cutting force. (Dependant on strength of operator).
 |
| illustration purpose only |
Freeze Dryers used for Biotech and Industrial applications can vary greatly. To accommodate the large range of requirements, Millrock Technology offers systems in either 304 stainless steel for non-pharmaceutical applications and 316L stainless steel for pharmaceutical applications. Condenser assemblies can be internal or external with either bulk or stoppering style shelf assemblies. Cylindrical chambers offer cost savings and can be supplied up to 80 square feet in shelf area. Features such as isolation valves and clean-in-place (CIP) piping can be provided. Millrock Technology works with each customer to fit their specific application needs. Selecting the right components and the right controls is critical to a successful freeze dryer project.
Click Here to see our Freeze Dryers Products
 |
| illustration purpose only |
The Four-Ball Tester is the standard test that used
to measure a lubricant’s extreme properties in metal to metal contact situation.
The test used to determine the load
carrying properties of a lubricant at high testload. The tester can perform
both Wear Preventative (WP) and Extreme Pressure (EP) analysis for measuring the wear and friction characteristic.In
the case of WP or EP lubricants the ability to resist scuffing is the
primary concern.
The Four-Ball Tester is a good laboratory tool for developing oil with
good engine wear control. The point
contact interface is obtained by
rotating a steel ball under load
against three stationary steel balls
that secured and placed in triangular pattern within a bath of lubricant.
The torque transferred between the rotating
and the stationary balls. The digital timer
can be used to control the duration
of the test. If the torque exceeds a preset, or the balls weld during a test power to the drive motor is automatically
turned off .
No comments:
Post a Comment